Hey there, how can we help?
Find the answers to your questions.
If you cannot find answer then contact us.
Undet Clipping Box block

Use the Clipping Box to navigate between point clouds. Undet loads all points in the Clipping Box when the point count is less than the maximum point count. The maximum point count can be set manually in the Undet Density toolbar according to your system hardware parameters. If your clipping box is too big to load all points you will only see the preview points.
![]() | [On/Off] – Enabled / disabled Undet Clipping box. |
![]() | [Toggle viewsection] – Hide/Show viewsection boundaries. |
![]() | [Reset] – Resets clipping box to the full extent of the project. |
![]() | [Clip by Line] – Creates new Clipping box by defining a line and its thickness. |
![]() | [Clip by Rectangle] – Creates new Clipping box by defining a rectangle (note: use top or side view, to create a new clipping box). |
![]() | [Switch Grips] – Activates Clipping Box grips to resize and change the orientation of grips. (Tips & Tricks: use CTRL+SHIFT+1 shortcut to activate tools to move an active Clipping Box using grips.) |
The clipping box can be moved to any area of a point cloud to see a more detailed view by using the arrows attached to the sides of the clipping box.
|
|
|
Full extent of Undet project point cloud, without Clipping box. |
Clipping Box is created, but currently disabled. |
Enabled Clipping Box |
When choosing [Clip by Line], in the command line you will have several options: Select start point [Thickness/Ucs/View/ucs And view/None] None:
Thickness |
– enter the line thickness for a new “Clipping Box” by typing “T” into the command line |
Ucs |
– with this option, the UCS plane will be set to the center of the new “Clipping box” center, by typing “U” into the command line |
View |
– with this option, the view of a new “Clipping box” will be rotated to the section line profile, by typing “V” into the command line |
ucs And view |
– with this option, the view of the new “Clipping box” will be rotated to the section line profile and UCS adjusted to the center of the new “Clipping box”, by typing “A” into the command line |
None |
– new “Clipping box” will be created without changing of View or UCS, by typing “N” into the command line |
Examples:
|
|
|
Creating a new “Clipping Box” with a thickness of 0.1 meters with the “ucs And view” option selected. |
You will get a slice view and UCS plane on the section center, ready to draw the section view |
|
|
|
|
Creating a new “Clipping Box” with a thickness of 1 meter with the “ucs And view” option selected. |
You will get a slice view and UCS plane on the section center, ready to draw the elevation view. |
Examples with a different project GRID (enabled / disabled clipping box)
LiDAR data management and analysis (UAV data) |
|
Preview points |
All points loaded with clipping box (view section) |
|
|
Buildings, Infrastructure objects, Plants |
|
Preview points |
All points loaded with clipping box (view section) |
|
|